Set of 12 flame-retardant textile sprays – Eurotextil

• 100% cotton, 125 g/m² to 315 g/m²
• 100% linen, 135 g/m² to 280 g/m²
• 100% polyester, 100 g/m² to 373 g/m²
• 100% polypropylene, 70 g/m²
• Cotton (60%) and linen (40%) blend, 235 g/m²

For any other fabric, additional tests may be required by the quality control committees. We encourage you to check this before starting your project.

The M1 dosage is based on the weight of your fabric, measured in “points”: one 0.5L spray bottle is equivalent to 100 points. The number of points required varies from 20 points/m² (very lightweight fabric) to 70 points/m² (very heavyweight fabric). This pack of 12 provides a total of 1200 treatment points. You must multiply the surface area to be treated by the number of points required for your fabric, then divide by 100 to determine the exact number of spray bottles to use.

Yes. The sprayer allows for precise, saturation application, crucial for M1 fire resistance. Saturate the fabric on both faces until the excess runs off. Run-off is the condition of the test report. The easy handling and portability of the bottles make treating hanging fabrics (curtains) or complex designs much easier than using a large can. The fabric is impregnated until saturation and run-off. Fibres other than those covered by the test report are validated case by case before treatment.

• Never mix with water.
• Storage temperature: minimum 15°C. Do not expose to temperatures exceeding 50°C/122°F.
• Shake well before each use.
• Protect from freezing.
• Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources.
• Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
• Use only in a well-ventilated area.
• Protect from sunlight.
• Do not use for any purpose other than that for which the product is intended.
• Shelf life: 24 months in its original, unopened, airtight container.

The information on this product sheet is provided for informational purposes only. Refer to the instructions for use, technical data sheet, and safety data sheet for further information.

CLP classification — Regulation (EC) No 1272/2008. Flammable liquids, category 2 (H225). Serious eye damage / eye irritation, category 2 (H319).

Pictograms: GHS02 (flame), GHS07 (exclamation mark). Signal word: Danger.

Hazard statements
H225 — Highly flammable liquid and vapour.
H319 — Causes serious eye irritation.

Precautionary statements

• P210 — Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
• P233 — Keep container tightly closed.
• P280 — Wear protective gloves and eye protection.
• P303+P361+P353 — IF ON SKIN: Take off immediately all contaminated clothing. Rinse skin with water or shower.
• P337+P313 — If eye irritation persists: Get medical advice / attention.
• P370+P378 — In case of fire: Use sand, alcohol-resistant foam or dry extinguishing powder to extinguish.
• P403+P235 — Store in a well-ventilated place. Keep cool.

This information is taken from safety data sheet FDS_EUROTEXTIL version 26.1 of 04/08/2026, which prevails and is supplied on request.

Compliance file — Contact us to receive the compliance file in Specimen format: application classification test report, classification test report and instructions for use.

This liquid fabric flame retardant will allow you to delay the combustion of your textiles and prevent fires from starting. The product is available in liquid form, is odorless and colorless, and comes in spray bottles or containers.

Flame retardant treatment makes textiles difficult to ignite, a reaction-to-fire requirement that depends on the use of the fitting and is assessed with your inspection body and hotels/restaurants/cafes. EUROTEXTIL covers four fibres under a single test report, no. P258195-DEC/1: polypropylene 70 g/m², polyester 175 g/m², linen 230 g/m² and cotton 150 g/m². Any other fibre is validated before treatment. The pack of 12 ready-to-use spray bottles ensures a low unit price while offering the best logistical solution: it allows several teams to work simultaneously on large installations (curtains, decorations), optimizing time on site.

The 12-pack is the ideal solution for professionals (decorators, theatres, fitters) who prioritize multi-operator practicality and the rapid processing of numerous textile items.

Classification is simplified. You will receive a single application declaration in your package, along with all the corresponding compliance stickers for the 1200 treatment points. These stickers constitute formal proof of compliance with the M1 dosage. After applying the product in accordance with the instructions for use, the applying company completes, dates and signs the classification test report and affixes the stickers justifying the quantity used. The classification test report is a declaration by the applying company: it stays with the applicator, does not have to be returned to us, and we do not countersign it. It must be kept in the site safety register together with the instructions for use and the classification test report.

Classified M1 under the conditions of LNE classification test report no. P258195 – DEC/1 — LNE, a laboratory accredited for reaction-to-fire testing.