Flame retardant artificial plants – Euroflor

This ready-to-use spray is the simplest solution for bringing your artificial plant decorations (flowers, trees, plants) up to M1 fire safety standards in all Public Access Buildings (ERP).

The artificial plant fire retardant is a specific, colorless, and odorless solution designed to treat the plastic and synthetic fabric of decorative plants. These materials are often highly flammable. The product creates a protective barrier, allowing your artificial flowers, trees, or plants to achieve the M1 fire rating, which is the mandatory French fire safety standard for all decorations in Public Access Buildings (ERP) or Hospitality Establishments (CHR – Hotels, Restaurants, Shops). This treatment guarantees that your decorations comply with the law and ensure the safety of your establishment.

Our product is tested and certified M1 (in accordance with Standard NF P92-503). Certification is based on precise dosage: you must saturate the entire surface of the plant. The 0.5L spray bottle is ideal for small and medium-sized rooms. The M1 Certificate is included with your product. After application, you must complete the document, affix the compliance sticker (provided), and return it to us for final certification. The effectiveness of the treatment depends on adhering to the dosage instructions across the entire surface to be fireproofed. Find all our sizes on the Artificial Plant Fireproofing category page.

M1 according to Standard NF P92-512. Test Report No. 208356 – DEC/8.

1. 1. Refer to the scale for the use of our flame-retardant products specifically developed for artificial plants.
   2. Calculate, according to the type of artificial plants you need to fireproof, the number of points corresponding to your needs. The total should be divided by 100 (1 sprayer = 100 points). This will give you the exact number of sprayers to use.

1 sprayer = 100 points

The application must be meticulous, as all exposed surfaces must be treated. The 0.5L spray bottle is ready to use:

1. Preparation: Ensure the plant is clean and dry.
2. Application: Spray the artificial plant fire retardant thoroughly onto all leaves, flowers, and branches. It is crucial that the product penetrates and coats the synthetic fibers.
3. Drying: Allow to dry naturally (drying time varies).

For precise dosage: 1 liter of product treats approximately 8 m² of surface area (leaves and branches fully extended). The 0.5L spray bottle covers approximately 4 m². For larger trees, a 5L bottle is recommended.

The artificial plant fire retardant solution is colorless and non-toxic. Once dry, however, it leaves a glossy finish on the leaves and a slightly sticky feeling. It is recommended to test the product on a small, hidden area first. During application, work in a well-ventilated area and protect it from heat. The product is designed for indoor use only.

Once correctly applied and dried, the flame retardant effect on artificial plants is considered unlimited as long as the plants remain indoors, protected from washing and excessive humidity. If the plants are dusted while dry, the protection remains intact. Retreatment would only be necessary if the plant were washed or heavily rubbed, which would damage the flame-retardant coating. For any questions regarding its lifespan, please do not hesitate to contact us.

• Never mix or expose to water. This will cause white stains.
• Storage temperature: minimum 15°C.
• Do not expose to temperatures exceeding 50°C/122°F.
• Shake well before each use.
• Protect from freezing.
• Pressurized container: may burst if heated.
• Do not pierce or burn, even after use.
• Use only in a well-ventilated area.
• Protect from sunlight.
• Do not use for any purpose other than that for which the product is intended.
• Shelf life: 24 months in its original, unopened, airtight container.

The information on this product sheet is provided for informational purposes only. Refer to the instructions for use, technical data sheet, and safety data sheet for further information.